Partition Not found / Please Set the Partition

[teastain2]

@lilydoh Partition Scheme is
'Huge APP (3MB No OTA/1MB SPIFFS)'

[lilydoh]

@teastain2 I'll try this and will report back. Thank you.

[lilydoh]

@teastain2 Unfortunately I'm receiving the same error:

15:03:11.099 -> Started AP mode host name :LilyGo-Cam-34:85IP address is :192.168.4.1
15:03:11.358 -> E (3912) MFN: Partition Not found
15:03:11.358 -> E (3912) MFN: Please Set the Partition

Partition Scheme: Huge App (3MB no OTA / 1mb Spiffs)

[teastain2]

ooo. Can you confirm what ESP32 you have?
LilyGO makes a confusing array of 7080g boards!

[lilydoh]

@teastain2

This is the board I purchased: LILYGO T-SIM7080G-S3 ESP32-S3 SIM7080 Development Board Supports Cat-M NB-Iot WIFI Bluetooth 5.0 With GPS Flash 16MB PSRAM 8MB

[lilydoh]

When I select "Board Info" in Arduino IDE, I receive this:

[teastain2]

@lilydoh Thanks for the info.
I see that Arduino IDE thinks it is a C3. That happens on my other LilyGO boards and I think it is a bug in the IDE.

You have to make sure the ESP32S3 Dev Module is the board type.

Can you try my sketch called
'Generic_tick_tock_serial_test.ino' ?
It is available here:
https://github.com/teastainGit/LilyGO-T-display-S3-setup-and-examples

This will make sure that there is nothing in your big sketch that is giving the fault.
-Terry

[lilydoh]

This post is deleted!

[lilydoh]

@teastain2

08:54:08.992 -> tick
08:54:08.992 -> tock
08:54:08.992 -> tick
08:54:08.992 -> tock
08:54:09.521 -> tick
08:54:10.497 -> tock

[teastain2]

@lilydoh Hey you found the Easter Egg!
So I suggest that you build up from there, as a form of de-bugging.
I am not familiar with sim-cams, so you may have to take it from here!
Keep me posted, tho' !!!
-Terry

[lilydoh]

Does anyone else have any advice on what’s going on here?