@teastain2 I'll try this and will report back. Thank you.

Does anyone else have any advice on what’s going on here?

@teastain2

08:54:08.992 -> tick
08:54:08.992 -> tock
08:54:08.992 -> tick
08:54:08.992 -> tock
08:54:09.521 -> tick
08:54:10.497 -> tock

When I select "Board Info" in Arduino IDE, I receive this:

@teastain2

This is the board I purchased: LILYGO T-SIM7080G-S3 ESP32-S3 SIM7080 Development Board Supports Cat-M NB-Iot WIFI Bluetooth 5.0 With GPS Flash 16MB PSRAM 8MB

@teastain2 Unfortunately I'm receiving the same error:

15:03:11.099 -> Started AP mode host name :LilyGo-Cam-34:85IP address is :192.168.4.1
15:03:11.358 -> E (3912) MFN: Partition Not found
15:03:11.358 -> E (3912) MFN: Please Set the Partition

Partition Scheme: Huge App (3MB no OTA / 1mb Spiffs)

@teastain2 I'll try this and will report back. Thank you.

Trying to run MinimalCameraExample.ino via Arduino IDE, but keep getting the following error. Any ideas on how I "set the partition"?

Error:

12:57:44.893 -> Started AP mode host name :LilyGo-Cam-34:85IP address is :192.168.4.1
12:57:45.154 -> E (3914) MFN: Partition Not found
12:57:45.154 -> E (3914) MFN: Please Set the Partition[ m

Board: Lilygo 7080G
Board Set: ESP32S3 Dev Module
Partition Scheme: 16M Flash(3MB APP/9.9MB FATFS)