Posts made by m4biz

@teastain2
Wonderful!!!
Works.
Thanks for you time.

@teastain2
Nothing to do.
I've tried all but don't works.

@teastain2
Shure, the adapter is set on 3.3 V.
Anyway, in the circuit you have uploaded I see VDD3V3

I don't know where must I take this voltage from the ESP32 module or from the FT232 adapter ?

@teastain2
Hi.
When you say VDD3V3, you mean:
a) that on the FT232-AZ USB auf TTL adapter:

or
b) that on the LilyGO ESP32 module:

@teastain2
Ok.
I'll try.
Thanks for now.

@teastain2
Hi. Thanks for you reply again.
This my configuration:

Anyway.
I've tried to press :

1. Boot
2. Reset (while boot is pressed)
3. release Reset (while boot is pressed)
4. release Boot
   But nothing change.
   I receive the same error.
   Where am I wrong ?

@teastain2
Hi.
Thanks for your reply.
I've USB to TTL converter but when I try to upload an arduino's sketch I receive this error:

I think it depend on the card must be in boot mode (like pushing a button on other kind of ESP32 cards) but here there are no buttons,...
How do you put the card in boot mode so that may you flash it?

Hi.
I've just purchased an T-01C3 board.
I don't know how to flash it.
May you help me?

Hi.
I've newbie to LILYGO boards.
I've just purchased a LILYGO TTGO T Internet POE ESP32 WROOM LAN 8720A and I'd like to program it by means Arduino IDE.
Anyway , I don't know wich board must I choose in Arduino IDE .
May you help me?
Thanks in advance.