T-Deck Won't Go Into DFU mode
-
I have 2 T-Decks which I purchased when they first came out. I'm just getting around to attempting to install Meshtastic on these two separate devices. I cannot seem to get this into a DFU state to load the firmware. Plug in USB while holding trackball doesn't work. Including the RST button into the mix isn't working either. Any other suggestions?
-
I'm having the same issue, I know I got mine the day they released them and I wonder if the BOOT is bad or some tweek was made to the later editions.
-
@fender21 Did you find a solution. I have exactly the same issue. Brand new devices out of the box. They have firmware on them which boots and runs diagnostics. All Diags appear to run successfully. I cannot get it to go into DFU Mode. Tried many combinations. When booted in diags the USB port is not recognizing anything either.