@teastain2 sorry, forgot board information. It has the following info on the chip:

Lilygo
868/915Mhz
Model: LORA32
SX1262

Thank you again

@teastain2 I was following a video I saw about adding GPS and screwed up. They went the route of removing the plug and soldering to the pads. Went the route of removing it based on that. Realized my mistake afterward. Ruined the tx and rx pads in the process. Patience is not always my approach. I have another T-Deck and am NOT removing it from that one. Still very new to these devices and Meshtastic. Glad I can use the other pins for GPS use. I guess I need to do some reading. Thank you for the help. I appreciate it very much

I removed the grove connector and in my haste, damaged the solder points on the board. Is there another location to solder wires to for tx and rx data? I can get ground and vcc from the solder points down toward the bottom right of the back of the board. Thanks in advance.