@teastain2
Thanks, I'll take step 3

@teastain2
It doesn't work I'm very sad I'll try the external way just to test the tdeck microphone thing I got that error You're very kind in answering me

@kil

@kil Tools ->

•              Board:"ESP32S3 Dev Module"
  

•              USB CDC On Boot:"Enable"
  

•              USB DFU On Boot:"Disable"
  

•              Flash Size : "16MB(128Mb)"
  

•              Flash Mode"QIO 80MHz
  

•              Partition Scheme:"16M Flash(3M APP/9.9MB FATFS)"
  

•              PSRAM:"OPI PSRAM"
  

•              Upload Mode:"UART0/Hardware CDC"
  

•              USB Mode:"Hardware CDC and JTAG"
  

@kil NOTE: the T-Deck must first be placed into DFU mode by pressing down the trackball, holding it down the clicking the small reset button on the left-hand side. but no change

@teastain2 I WILL TRY THIS :The programming and burning interface of ESP32C3 is located at the 6Pin header on the side of the RST button, and the order starts from the top of the RST button, which are 3V3, GND, RST, BOOT, RX, TX

@teastain2

my tdeck does not respond it says there is an error in the usb driver
I already did the boot thing but it gives me an error
use arduino ide does anyone know how to fix this error