T3 v1.6.1 - mode Lora Transmitter nd Receiver
-
Hi guys i have a 2 plates, and i wont to try LORA comunication P2P, but when i upload program with IDE arduino, its not work, no work scren, no work program. Anyone can sent me link with correct program . thansk
-
How far into the trouble shooting are you, and what exactly is not working ? Also can you post a slim piece of code that shows what is not working ?
-
@eflorea salut!
look at, i have :
- model: t-beam-v1.1 (SX1262) i wont uploaded sample LORA TRANS ans LORA RECEIVER for 868Mhz( nothing)
-model: T3_v1.6.1 i wont to upload the same sample, and nothiung i have this eeror:
i use IDE ARDUINO :
rst:0x8 (TG1WDT_SYS_RESET),boot:0x13 (SPI_FAST_FLASH_BOOT)
configsip: 188777542, SPIWP:0xee
clk_drv:0x00,q_drv:0x00,d_drv:0x00,cs0_drv:0x00,hd_drv:0x00,wp_drv:0x00
mode:DIO, clock div:1
load:0x3fff0030,len:1184
load:0x40078000,len:13260
load:0x40080400,len:3028
entry 0x400805e4
ets Jun 8 2016 00:22:57 - model: t-beam-v1.1 (SX1262) i wont uploaded sample LORA TRANS ans LORA RECEIVER for 868Mhz( nothing)
-
Just saw your message, a buddy of mine has a T-Beam, not sure what frequencies his operates at, so I will get my hands on it and take a look.