Can't upload sketch after using Lilygo as a USB keyboard and mouse emulation

franic

I have uploaded a sketch that transform my lilygo ESP32-S3 in a USB keyboard and mouse emulator
The sketch works, but I can't upload a new sketch as the serial port is then disabled.
How can I erase the sketch or upload a new sketch ?
Is it possible to have serial port and USB keyboard and mouse emulator at the same time ?
(It's possible with an ardunion leonardo)

#include "USB.h"
#include "USBHIDKeyboard.h"
#include "USBHIDMouse.h"

USBHIDKeyboard Keyboard;
USBHIDMouse Mouse;
uint8_t buf[200];
void setup() {
// open the serial port:
Serial.begin(115200);
// initialize control over the keyboard:
Keyboard.begin();
Mouse.begin();
USB.begin();
Keyboard._onGetDescriptor(buf);
}

void loop() {
// check for incoming serial data:
if (Serial.available() > 0) {

// read incoming serial data:
char inChar = Serial.read();
Serial.print(inChar);
// Type the next ASCII value from what you received:
Keyboard.press(inChar);
Keyboard.releaseAll();

}
Mouse.move(20, 20, 0, 0);
Keyboard.press('Q');
Keyboard.releaseAll();
delay(3000);
}

teastain2

You need to enter upload mode by first pressing Boot, then press and release Reset, then release Boot.
After upload you may have to unplug the board and plug it back in.

You can also "erase all flash before uploading" but it takes a long minute!

I have no experience with keyboards and mouse on ESP32, as I consider a Rasp pi a better choice for 'that sort of thing'.